Repair guide

Gas Burner Not Lighting but Clicking? Here’s How to Fix It

Practical fixes from Al‑Haram's Abu Dhabi technicians, and when to call a pro.

Gas Burner Not Lighting but Clicking? Here’s How to Fix It, Al Haram Electrical Appliances Repairs Shop, Abu Dhabi

Why your gas burner is clicking but not lighting: the usual causes

CauseHow to tellWhat fixes it
Burner cap misalignedThe flat metal cap sits crooked or rocks when you touch it. The spark fires, but the gas does not flow past it evenly.Lift the cap and set it flat on the burner head so it sits level and does not move.
Wet burner or capIt started after cleaning the hob, a pot boiling over or wiping with a wet cloth. The click may sound weaker.Take off the cap and burner head, dry them fully and leave the burner area to air-dry for a few hours.
Blocked burner portsYou can see food, grease or soot in the small holes around the edge of the burner head.Clear the holes with a pin or a stiff dry brush. Avoid toothpicks, which can snap off inside.
Gas not reaching the burnerYou hear no soft hiss when you turn the knob. It often happens with an empty cylinder or just after a cylinder change.Check the cylinder or kitchen gas valve is on and the cylinder is not empty. Air left in the line after a change clears after a few short tries.
Blocked gas jetOnly one burner fails, with no gas flow at all, while the others light normally. The jet is the small brass nozzle under the burner head.A technician cleans or replaces the jet. Do not push wire into it, as this enlarges the hole and spoils the flame.
Dirty or cracked igniter electrodeThe spark is weak, yellow or jumps to the wrong place. The electrode is the small white ceramic pin beside the burner.Wipe it with a dry toothbrush. A cracked electrode or a damaged ignition wire needs replacing.
Faulty thermocouple or flame-failure deviceThe burner lights but goes out as soon as you let go of the knob.Hold the knob in for 10 to 15 seconds after lighting. If it still goes out, a technician replaces the thermocouple.

How to fix a gas burner that clicks but won’t light, step by step

  1. Start with safety. If you can smell gas strongly, stop here and follow our guide to a smell of gas from your stove. Otherwise turn every knob to off and let the hob cool.
  2. Switch off the power to the hob. Use the cooker switch on the wall or unplug it, so the spark cannot fire while you work.
  3. Lift off the cap and burner head. Look for water, spilled food and grease. Dry everything with a clean cloth.
  4. Clean the burner ports. Clear each small hole with a pin or a stiff brush. Wash greasy parts in warm soapy water, then let them dry completely before refitting.
  5. Clean the electrode. Brush the white ceramic pin with a dry toothbrush. Check it for cracks and make sure its wire is not loose.
  6. Refit the parts correctly. Seat the burner head so its notch lines up, then set the cap flat. It should not rock or sit to one side.
  7. Check the gas supply. Make sure the cylinder valve or kitchen gas valve is on. Try another burner. If no burner lights, the problem is the supply, not the burner.
  8. Test it the right way. Restore power and hold the knob in for 10 to 15 seconds after the flame appears. Click for no more than about five seconds. If it does not light, turn it off and wait a minute.

When to stop and call a gas stove technician

  • You smell gas that does not clear once the knobs are off. Turn off the supply, open the windows and, if the smell is strong, leave and call Civil Defence on 997.
  • The burner lights but dies when you release the knob. Never wedge a knob in to keep it lit. The thermocouple needs replacing.
  • The igniter keeps clicking with every knob off, even after the hob has dried. The ignition switch is likely faulty.
  • The flame lifts off the burner, burns yellow and sooty, or lights with a loud pop.
  • The electrode is cracked, the ignition wire is damaged, or the fault is in a gas valve, jet or pipe.

Al Haram Electrical Appliances Repairs Shop repairs clicking and non-lighting burners at home across Abu Dhabi, usually the same day. Book gas stove repair in Abu Dhabi or call +971 50 699 7974.

Why burners stop lighting in Abu Dhabi kitchens

Homes near the coast, including much of Abu Dhabi island, have humid air. Steam settles on cool burner parts, so a damp cap often causes clicking without a flame. Boil-overs from rice and pasta also run straight into the ports.

Dust and sand mix with grease to clog the burner holes. Villas and older flats often use a cylinder, so air in the line after a change is a frequent cause. Many apartment towers use piped central gas, where a closed kitchen valve is the first thing to check.

How to stop it happening again

  • Wipe spills as soon as the hob is cool, before they dry inside the ports.
  • Dry caps and burner heads fully after washing, before you put them back.
  • Use a lid or lower the heat to stop pots boiling over.

Related repair guides and services

Gas burner not lighting clicking: your questions answered

Is it safe to keep clicking the igniter until the burner lights?
At Al Haram Electrical Appliances Repairs Shop, we advise clicking for no more than about five seconds at a time. If the burner has not lit, turn the knob off and wait at least a minute so unburnt gas can clear. Then try again. If you notice a smell of gas building up, turn off the supply, open the windows and stop trying.
Why does my burner light but go out when I let go of the knob?
Al Haram Electrical Appliances Repairs Shop technicians usually find a weak or dirty thermocouple, the small metal probe beside the burner that proves a flame is present. Hold the knob in for 10 to 15 seconds so it can warm up. If the flame still dies on release, the thermocouple or flame-failure device needs replacing by a technician.
Is it worth repairing a burner that won’t light, or should I replace the hob?
According to Al Haram Electrical Appliances Repairs Shop, most clicking burners are fixed by cleaning, a new electrode, a thermocouple or a spark module. Replacing the whole hob is rarely needed. The cost depends on the part, and our technician quotes it after diagnosing the fault at your home, before any work starts.
Can I get a gas burner fixed the same day in Abu Dhabi?
Al Haram Electrical Appliances Repairs Shop repairs gas burners at home across Abu Dhabi, usually the same day. We are open daily from 8 AM to 10 PM. Call or WhatsApp +971 50 699 7974 with your hob brand and a short description of the fault, and we will arrange a visit at a time that suits you.
Still stuck? If these steps don't fix it, Al‑Haram offers same-day repair across Abu Dhabi. Call or WhatsApp +971 50 699 7974 and we'll take it from here.
Call nowWhatsApp