Repair guide

Dishwasher Not Cleaning Dishes Properly? Causes and Fixes

Practical fixes from Al‑Haram's Abu Dhabi technicians, and when to call a pro.

Dishwasher Not Cleaning Dishes Properly? Causes and Fixes, Al Haram Electrical Appliances Repairs Shop, Abu Dhabi

Why your dishwasher is not cleaning dishes properly: the usual causes

CauseHow to tellWhat fixes it
Clogged filterBits of food are redeposited on dishes, and the bottom of the tub looks dirty.Twist out the filter under the lower spray arm and wash it under the tap.
Blocked spray-arm holesDishes in one area stay dirty. The small holes in the spray arms are clogged with scale or food.Remove the arms and clear each hole with a toothpick, then rinse.
Hard-water scaleA white film on glasses and the inside of the tub. Dishwasher salt runs out or is never added.Fill the salt container, set the water hardness on the machine, and use rinse aid.
Overloading or poor loadingSpray arms knock against tall items or cannot turn. Bowls face each other and block the water.Load with dirty faces towards the centre and leave space for the arms to turn.
Wrong or old detergentDetergent tablets stay undissolved or powder is lumpy from damp.Use fresh dishwasher detergent stored in a dry place, and never washing-up liquid.
Water not heatingDishes and the tub are cold at the end of a normal programme, and grease stays on plates.A technician tests the heating element, the temperature sensor and the heater controls.
Weak wash pumpYou hear little spraying sound and the arms barely turn even when clean.A technician checks the wash pump, which pushes water through the spray arms.

How to fix a dishwasher that doesn’t clean properly, step by step

  1. Switch off and unplug the dishwasher before you remove any parts.
  2. Clean the filter. Take out the bottom basket, twist out the round filter and wash it with warm water and a soft brush.
  3. Clear the spray arms. Most lower arms lift off, and upper arms unscrew or unclip. Poke a toothpick through each hole and rinse the arm under the tap.
  4. Top up salt and rinse aid. Fill the salt container in the floor of the tub with dishwasher salt. Fill the rinse-aid dispenser on the door.
  5. Set the water hardness. Check the manual for the hardness setting. A setting that is too low lets limescale build up.
  6. Load correctly. Spin each spray arm by hand after loading. Nothing should block it.
  7. Run a cleaning cycle. Run an empty hot programme with a dishwasher cleaner or descaler, then test with a normal load.

If dishes come out clean but wet, see our guide on a dishwasher not drying. If dirty water stays in the tub, read about a dishwasher not draining.

When to stop and call a technician

  • Dishes and the tub stay cold at the end of a hot programme.
  • You cannot hear water spraying during the wash.
  • The machine trips the breaker or gives a burning smell.
  • A heater or pump error code shows on the display.
  • Dishes are still dirty after you clean the filter and spray arms and use salt.

Heaters and wash pumps sit under the tub, close to mains wiring. Al Haram Electrical Appliances Repairs Shop repairs this at home across Abu Dhabi, usually the same day. Our experienced technicians carry common parts for dishwasher repair in Abu Dhabi. Call or WhatsApp +971 50 699 7974, daily from 8 AM to 10 PM.

Cleaning problems and Abu Dhabi water

Limescale is a common complaint in Abu Dhabi kitchens. It shows as a white film on glasses and a chalky layer inside the tub. Scale also blocks the tiny holes in the spray arms, so water stops reaching some dishes.

The fix is simple. Keep the salt container full so the built-in water softener can work, use rinse aid, and descale the machine every month or two. Oily dishes from rich, home-cooked meals also need a hotter programme rather than an eco or quick wash.

How to stop it happening again

  • Scrape food into the bin, but there is no need to pre-rinse.
  • Clean the filter once a week and the spray arms once a month.
  • Keep dishwasher salt and rinse aid topped up.
  • Use the intensive programme for greasy pots and pans.

Related repair guides and services

Dishwasher not cleaning: your questions answered

Why are my glasses cloudy after the dishwasher?
At Al Haram Electrical Appliances Repairs Shop, we usually find cloudy glasses come from limescale. The salt container is empty, the hardness setting is too low or rinse aid has run out. Fill the salt and rinse aid, then run an empty cycle with a descaler. If glasses are etched and the film will not wipe off, the damage is permanent.
Do I really need dishwasher salt in Abu Dhabi?
Al Haram Electrical Appliances Repairs Shop technicians recommend it for most homes. Dishwasher salt recharges the built-in water softener, which stops limescale forming on dishes, spray arms and the heater. Use only coarse dishwasher salt, never table salt. Tablets labelled all-in-one do not replace salt if your machine has a salt container.
Should I repair or replace a dishwasher that doesn’t clean well?
According to Al Haram Electrical Appliances Repairs Shop, most cleaning problems are fixed by maintenance, not new parts. If the heater or wash pump has failed, a repair is still often worth it on a machine in good condition. The price depends on the part, and our technician quotes it after diagnosing the fault at your home.
Can I book a same-day dishwasher repair in Abu Dhabi?
Al Haram Electrical Appliances Repairs Shop visits homes across Abu Dhabi, usually the same day. Call or WhatsApp +971 50 699 7974, daily from 8 AM to 10 PM. Tell us your dishwasher brand and what you see on the dishes, so our technician arrives prepared.
Still stuck? If these steps don't fix it, Al‑Haram offers same-day repair across Abu Dhabi. Call or WhatsApp +971 50 699 7974 and we'll take it from here.
Call nowWhatsApp