Why your washing machine is not draining: the usual causes
| Cause | How to tell | What fixes it |
|---|---|---|
| Blocked pump filter | Water stays in the drum and the pump hums. The filter often holds coins, hair clips, lint or a small sock. | Drain the water out and clean the filter behind the small flap at the bottom front. |
| Kinked or squashed drain hose | The machine was pushed back recently. The grey ribbed hose at the back is bent or trapped against the wall. | Pull the machine out and straighten the hose so it runs in a smooth curve. |
| Clogged drain hose or sink connection | The hose is clear of kinks but water still backs up. The kitchen sink may also drain slowly. | Disconnect the hose, flush it with a tap, and clear the sink trap or standpipe it drains into. |
| Something stuck in the pump impeller | The pump makes a rattling or grinding sound, or the small fan blade (impeller) inside will not turn. | With the filter out, remove the object by hand. If the blade still sticks, the pump needs a technician. |
| Failed drain pump | Filter and hose are clear, but you hear no pump sound at all, or only a weak hum with no water moving. | A technician tests the pump and replaces it if it has burned out or seized. |
| Pressure switch or control fault | The machine shows a drain error code but the pump is healthy. The pressure switch tells the board how much water is inside. | A technician checks the switch, its small air hose and the wiring to the control board. |
How to fix a washing machine that won’t drain, step by step
- Switch off and unplug the machine. Turn off the water tap behind it as well. Never open the filter while the machine is plugged in.
- Get ready for water. Lay old towels on the floor and find a shallow tray or baking dish. A full drum holds more water than one tray, so drain it in batches.
- Drain through the emergency hose. Open the small flap at the bottom front. Many machines have a thin drain tube beside the filter. Pull out its cap and let the water run into your tray.
- Clean the pump filter. Unscrew the round filter anticlockwise, a little at a time. Pull out lint, coins, buttons and anything else, then rinse it under the tap.
- Check the impeller. Shine a torch into the filter opening. Turn the plastic blade gently with a finger. It should move, perhaps a little stiffly. Remove anything wrapped around it.
- Check the drain hose and sink trap. Pull the machine forward and straighten any kink. If the hose drains into the sink trap, run the kitchen tap. If the sink drains slowly, clear the trap first.
- Refit and test. Screw the filter back in firmly and close the emergency tube. Plug in, open the tap and run a drain or spin programme. Watch the filter for drips and listen for the pump.
If the machine still holds water, the drum is full again, or the door stays locked, stop there. See also our guide on a washing machine that is not spinning, as the two faults often go together.
When to stop and call a technician
- The pump hums or stays silent even with a clean filter and a clear hose.
- You notice a burning smell or see scorch marks near the pump at the bottom.
- Water has reached the plug, the socket or the floor around electrics.
- The door will not unlock while water is inside. Do not force the door lock.
- The same drain error code keeps coming back. Our appliance error code guide explains what to note down.
A seized pump or a control fault needs testing with a meter. Al Haram Electrical Appliances Repairs Shop repairs this at home across Abu Dhabi, usually the same day. Our experienced technicians carry common parts for washing machine repair in Abu Dhabi. Call or WhatsApp +971 50 699 7974, daily from 8 AM to 10 PM.
Why drainage problems are common in Abu Dhabi homes
Many Abu Dhabi families wash a load or two every day, so lint builds up in the filter quickly. Beach towels and children’s clothes bring in fine sand. Sand settles in the bottom of the drum and the pump filter, and it can wear the impeller.
In many apartments the washing machine drains into the same trap as the kitchen sink. Grease and food waste from the sink then narrow the pipe. Limescale from hard water can also coat the hose and the filter housing over time.
How to stop it happening again
- Clean the pump filter about once a month, or more often with sandy loads.
- Empty pockets and shake sand out of beach towels before washing.
- Put small items, such as baby socks and bra wires, in a mesh laundry bag.
- Use the right amount of low-foam detergent made for automatic machines.
- Leave a gap behind the machine so the drain hose is not crushed.
Related repair guides and services
- Washing machine repair in Abu Dhabi
- Washing Machine Not Spinning Properly? Causes and Fixes
- Washing Machine Leaking Water From the Bottom? Quick Fixes
- Appliance Showing an Error Code? What It Means and What to Do
- All appliance repair in Abu Dhabi
- More appliance troubleshooting guides
